How to Program your One For All® remote
(Model URC-3030)
Set Up
To set up the remote for your Device(TV,VCR,CABLE).
- Turn on the device (TV or VCR,CABLE) that you want to operate.
- Press the device button and release.
- Press and HOLD SETUP-- after about three seconds, the red light will blink twice-release SETUP.
- Enter the four digit code you found for your device. If you put the code in correctly, the light on the remote will blink twice.
Remember: VOL UP = 1, VOL DOWN= 2, CH UP = 3, CH DOWN = 4
- Aim the One For All® 3 at your device and press POWER. The device should turn off.
- If your device does not turn off, repeat steps 2-4, trying each code listed for the brand of your device. Device Set-Up Codes
NOTE: Some VCR's did not have a POWER key on the original remote. Try putting a tape in your VCR and using the PLAY key to test the codes.
menu
Re-Assigning Device Keys
You can use the One For All® 3 to operate a second TV,VCR, or CABLE box. To do so, you must re-assign one of the device keys (TV ,VCR,or CABLE) to operate your second unit.
The examples below shows you how to re-assign the device keys.
TV to VCR
- Press Setup (hold 2 blinks)
- Tap CH-, CH-, VOL +
- Tap VCR and then TV
- Set up VCR on the TV key using the "Set Up" instructions (above)
VCR to TV
- Press Setup (hold 2 blinks)
- Tap CH-, CH-, VOL +
- Tap TV and then VCR
- Set up TV on the VCR key using the "Set Up" instructions (above)
CABLE to TV
- Press Setup (hold 2 blinks)
- Tap CH-, CH-, VOL+
- Tap TV and then CABLE
- Set up TV on the CABLE key using the "Set Up" instructons (above)
Any of the device buttons can be set to work any device this way.
menu
|